2015江西教格证面试：初中英语说课稿《where’s my back pack》.docVIP

2015江西教师资格证面试：初中英语说课稿《where’s my back pack?》 中公江西教师网 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm