东大2010高验报告.doc

数学实验报告 实验人员：院（系） __能源与环境_学号_ _姓名_ __ 实验地点：计算机中心机房 实验一 实验名称：泰勒公式与函数逼近 实验时间：2010年11月27 日 实验目的：利用Mathematica计算函数的各阶泰勒多项式，并通过绘制曲线图形，来进一步掌握泰勒展开与函数的逼近思想。 实验内容：1.对Y=COSX重复上面的实验 2.作出函数Y=ln(cosx^2+sinx) (- π/4, π/4)的函数图形和泰勒展开式图形，选取不同的X0和n，并进行比较。 实验心得：利用Mathematica计算函数的各阶泰勒多项式，并通过绘制曲线图形，进一步掌握泰勒展开与函数的逼近思想。 实验二 实验名称：定积分的近似计算 实验时间：2010年12月 25日 实验目的：为解决在许多实际问题中遇到的定积分，被积函数往往不能用算式给出，而通过图形或表格给出，或者虽然可用以个算式给出，但是要计算它的原函数却很困难，甚至于原函数可能是非初等函数的情况，运用进一步掌握定积分近似计算的思想。 实验内容：分别用梯形法和抛物线法计算定积分的近似值（精确到0.0001） 实验心得：定积分近似计算的思想，就是将积分区间分割成许多小区间，然后再小区间上近似计算小区边梯形的面积求和。 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the ap