进口切边机技术同描述.docVIP

Technical Contract of The high slitting line 高速切边机技术合同 上海大屯能源股份有限公司 2008年9月 APPENDIX 2.1 Design basis data 附件2.1 设计参数 2.1 DESIGN BASIS 2.1.1 MATERIAL-SPECIFIC DATA Alloys to be processed Material: Aluminum alloys Aluminum and its alloys: series 1xxx, 3xxx, 5xxx and 8xxx Material condition: strip in dry condition; with a maximum of 50 mg/m2 each side of rolling oil on the surface; Temper: Soft (O) – Hard (H19) Tensile strength: 80 … 450 N/mm2 Yield strength: 30 … 350 N/mm2 Elongation: 5 % The coils to be processed on the lines should be able to meet the requirements for cold rolled coils according to the applicable ISO or DIN standards. 2.1 基本设计 2.1.1 材料详细数据 合金 材料： 铝合金 合金系列：1xxx, 3xxx, 5xxx and 8xxx 材料条件：干带，每面最大轧制油含量为50 mg/m2 硬度： 软 (O) – 硬 (H19) 张力强度：80 … 450 N/mm2 屈服强度：30 … 350 N/mm2 延伸率： 5 % 根据ISO or DIN标准，处理卷能够达到冷轧卷的要求。 Specification of the coils to be processed (incoming material) Strip thickness: 0.10 up to 1.0 mm Width: 900 up to 2150 mm Coil I.D. 610 mm Coil O.D.: max. 2,200 mm Coil weight: max. 19,600 kg (without spool) Specific material weight: max. 9.6 kg/mm Spool size: ?605/?665 x 2350 mm Spool material: steel Spool weight: ~ 1,100 kg 来料数据 带材厚度：0.10 to 1.0 mm 宽度： 900 to 2150 mm 卷内径： 610 mm 卷外径： 最大2,200 mm 卷重： 最大19,600 kg (不带套筒) 单位重量：最大9.6 kg/mm 套筒尺寸：?605/?665 x 2350 mm 套筒材料：钢 套筒重量：~ 1,100 kg Specification of the finished material coils Cutting width: min. 420 mm； max. 2,100 mm Difference in strip width of： 150 mm Individual finished strips from One coil: (due to cross section of the incoming material) Number of strips Max. 2 (with centre scrap) Coil O.D.: max. 2,200 mm Coil I.D.: