第10章装配图3答案_拆画蝴蝶阀阀体.docVIP

10-16 读装配图：大于20到80的倒角C1 (1×45°)；螺孔大径与件6螺钉相同取M6、精度等级选公差带代号7H，阀体材料HT200为铸铁，那么螺钉旋入深度bm取1.5d=9，螺孔标注形式见教材237页表9-2。 （3）其余尺寸从装配图量取，按比例折算后圆整。 （4）注粗糙度：Ra值依据表面粗糙度选用表格选取（倒角紧固件通孔的表面和其他零件连接不形成配合的表面，如箱体、外壳、端盖等零件的端面不重要的紧固螺纹的表面间隙配合IT8～IT9级的孔（H8，H9） appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from