路桥施工计算专件使用教程之AutoCAD导入导出.docVIP

2.路桥施工计算专家软件使用教程之AutoCAD导入导出 路桥施工计算专家提供很好的AutoCAD导入导出功能，即AutoCAD中绘制的图形可以导入RBCCE系统，而在RBCCE系统中绘制的图形也可以很好的导入AutoCAD。利用这一功能可以实现有的图形快速化绘制。 （1）导入功能 第一步：在AutoCAD中绘制一个图形，如图2-1所示 图2-1 第二步：打开RBCCE软件，单击“从AutoCAD导入本系统”按钮,如图2-2 图2-2 第三步：切换到AutoCAD光标变成选择状态，如图2-3所示 图2-3 第三步：选择需要导入的图形（框选或者交选），单击右键完成导入，导入后的效果如图2-4 图2-4 （2）导出功能 第一步：在RBCCE系统中绘制一个图形，具体绘制方法和AutoCAD非常一致 第二步：选中要导入AutoCAD中的图形，如图2-5所示 图2-5 第三步：单击“拷贝到AutoCAD” 按钮，即可将所选图形导出到AutoCAD,如图2-6所示 图2-6 注意：有时候导出到AutoCAD有时候没有东西，需要双击鼠标滚轮，查看全部图形，既可以显示导出的图形。 路桥施工计算专家软件教程——胡帮义——2010-6-23 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged. 7.5.8 cables neat and clean, solid bindi