高二物理《交变流》计算题.docVIP

  • 5
  • 0
  • 约4.88千字
  • 约 5页
  • 2016-10-14 发布于贵州
  • 举报
高二物理《交变流》计算题

物理3-2《交变电流》计算题专项训练 1.如图(甲)所示,一固定的矩形导体线圈水平放置,线圈的两端接一只小灯泡,在线圈所在空间内存在着与线圈平面垂直的均匀分布的磁场.n=100匝,电阻r=1.0S=0.040m2R=9.0,其中Bm为磁感应强度的最大值,T为磁场变化的周期.1)线圈中产生感应电动势的最大值.2)小灯泡消耗的电功率.(3)在磁感强度变化的0~的时间内,通过小灯泡的电荷量. 3. 如图,匀强磁场的磁感应强度B=0.5T,边长为L=10cm的正方形线圈abcd共100匝,线圈电阻r=1Ω,线圈绕垂直于磁感线的轴匀速转动。外电路电阻R=4Ω。 求:(1)感应电动势最大值 (2)由图示位置转过60。角时的感应电动势值 (3)由图示位置转过60。角过程中产生的感应电动势值 (4)交流电压表的示数 (5)线圈转动一周在电阻R上产生的热量 (6)在周期内通过电阻R的电荷量为多少。 4. 一台交流发电机的输出电压为250V,输出功率为100kW,向远处输电用的输电线总电阻为8Ω。为了使输电线上损耗的功率不超过输送总功率的5%,且用户端刚好能得到220V交变电压,求:供电端的升压变压器和用户端的降压变压器的变压比应分别是多少? 5. 某发电站的输出功率为104kW,输出电压为4kV,通过理想变压器升压后向80km远处供电。已知输电导线的电阻率为ρ=2.4×10-8Ωm,导线横截面积为1.5×10- 4m2,输电线路损失的功率为输出功率的4%,求:⑴升压变压器的输出电压;⑵输电线路上的电压损失。 6. 图5-43为一输电系统,A地有一台升压变压器,B地有一台匝数比为10∶1的降压变压器,,A、B两地输电线的电阻是20Ω,求:(1)升压变压器输出端的电压.(2)若不用变压器,要在B地得到同样大小的电流和电功率,那么在A地要用多大的电压将电能输出?(3)两情况下输电线上损耗功率之比是多少? . be carried out in time rust and antirust paint twice. While skeleton construction curtain wall fireproof, antisepsis, mine should be simultaneously, all skeletons complete after the required time and concealed work inspection, acceptance of concealed work qualified before the stone plaque installed. Stone in stone before they can use pollution prevention performance, radiation energy, water absorption properties and bending strength of various performance testing protective treatment and six stone two times, and minimize chromatic aberration, chromatic aberration under control mainly in the specification sheet and the stone material control, specification order form should try to distinguish between separate parts orders. Stone cutting must be carried out according to the same part of the same batch, different parts of different facades of stone panels applied when cutting different symbols of letters or Arabic numerals differentiates, in order to facilitate timely and accurately identify different stone when installing special mounting parts. Resolutely put

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档