w7系统设置实实时播放麦克风声音.docVIP

八步设置让你实现实时播放麦克风的声音，可以在家体验k歌乐趣 条件：你的电脑为w7系统； 你的电脑有麦克风； 如果想要最佳体验，希望您配置一款立体声耳机 教程开始： 第一步：我们先点击下面的小喇叭，会出现如下的窗口 第二步：接下来我们点击合成器，会出现如下窗口 第三步：我们点击系统声音，会出现如下窗口 第四步：现在我们点击录制 第五步：这里我们先点击上面的麦克风，然后下面的属性按钮就会变亮，然后我们按属性按钮 这就是我们最后一个窗口了，请注意看上面的提示：麦克风音量输入为三十左右，关闭麦克风加强。 然后再选择侦听， 最后在我们的小框框里面打个勾勾就可以了。最后，你点击确定，就可以听到从你的音响里面传出来你动听的声音了 有什么疑问请通过我的id在百度知道里面像我求助。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad