上安镇学校208年消防安全.docVIP

上安镇学校2008年消防安全 应急演练预案 为了保障学校2008年秋季消防安全应急演练工作的顺利进行，我校安全工作领导小组特制订应急演练预案如下： 一、消防疏散、灭火演练的基本情况： 消防应急演练时间：2008年月日2008年月日2008年月日2008年月日2008年月日2008年月日 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring, threads do not have to bend. Insulating part should be careful not to press it into a Terminal, and make the loop doesnt make sense and to prevent bad head crimping, fell down, causing an open circuit. After wiring, may be tried. E, crimping Terminal crimping, wire and Terminal contact is good, solid, not subject to mechanical strain, and ensure th