PCI_MoldSpecs.docVIP

March 28, 2006 MOLD BUILDING STARDARDS Clamp slot height to be .875 from back of mounting plate If sprue pull pin has to be on the split of an insert an insert is required to contain the pin. No sprue pull pins on the split of an insert. Core pins to be held in with small retainer plates NOT set screws. This includes slides and the mold base and ejector sleeve core pins. Standard knockout hole locations, 2 holes 3.50 from center horizontally. Clearance holes thru bottom clamp plate, 1.25 diameter, tap knockout plate ?-13. Temperature sensor mounting holes as per drawing supplied. One sensor re