第1章 数控机故障诊断与维修的基本概念(中).docVIP

下面是它们的系统组成图片—— 快速查询图表 反向间隙 (M) 周期误差 (M) 螺旋误差 (T) 横向间隙 - 松动 (M) 主从伺服换向差 (M) 偏置变化 (T) 图形不连续 (T) ? 图形旋转 (T) 半径变化(M/T) ?? 反向跃冲 (M) 比例不匹配 (误差) (M) 伺服不匹配 (M) 垂直度 (M) 爬行 (M) 振动, 机器 (M) 三瓣误差(T) 直线度 (M) —用来提供电信号的基准电压（0V） 框架地—是以安全性及防止外来噪声和内部噪声为目的的地线系统。它是装置的面板、单元的外壳、操作板及各装置间接口的屏蔽线 系统地—是将框架地和大地相连接 1．5．2 数控机床的安装 数控机床的安装包括 基础施工、机床就位、连接组装、机床通电试车。 1．5．3 数控机床的调试 数控机床的调试包括机床精度调整、机床功能测试与机床试运行。 例：满负荷切削试验与主轴系统自动保护调整 材料：45 ， 刀具： φ160 / 8齿的盘铣刀 切削规范： n = 320 min-1 ，S＝1000 mm/min （Sz＝0.39 mm）， B＝110 mm ，t＝4 mm 计算可得： V＝161 m/min ，Vt＝440 cm3/min ，N＝17 kW 例 中国第二届机床工具博览会 UF41数控万能工具铣床 功能展示试件 凸轮加工例 1．插齿机上停凸轮 2．轴向变螺距的径向凸轮 3．轴向变螺距的沟槽凸轮 a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its interior is clean and free of any debris. By quality, mechanical, electrical and other professionals to conduct an examination of the rotor, confirm the wear cond