第74讲 电工子技术(二)(2010年新版).docVIP

例题： 1．真空中两个静止的点电荷之间的作用力与这两个点电荷所带电量的乘积成正比,与 它们之间距离的（B )成反比。 (A)一次方; (B)二次方; (C)三次方; (D)四次方。 2.均匀带电长直导线半径为1cm,线电荷密度为η,其外部套有半径为2cm的导体圆 筒,两者同轴。它们之间的电势差等于(D )。 (A);...(B) ; (C) ; (D) 。 3．图 8-1-6 所示电路中，当开关 S 放在 a 位置，读数为 4A ，则当 S 放到 b 位置，读数为（C）。 A . 3A； B . 4A ；C . 5A ；D . 6A Es＝8×（4＋2）＝48V；b位置时，用叠加原理，只有Es时，读书为4A，只有12V电压时，读书为12/(4+2)/2=2/2=1A 叠加后供5A。 4.如图8－18所示的电路中，A、B两点的电位差为（A） A 0；B －5V；C 6V；D 10V 令UA＝0，则，Uc＝1×2＝2V UB＝Uc+3-1*5=0. UAB=0  a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its interior is clean and free of any debris. By quality, mechanical, electrical and other professionals to conduct an examination of the rotor, confirm the wear condition of the rotor. Special equipment inspection and rotor through the preparation tool before loading inventory, check to confirm that it appears intact, complete tool, tools required for use of wire