N487导缆器度监控方案R1.docVIP

N487导缆器 精度方案 N4 DIMENSION CONTROL PROCEDURE OF FAIRLEADER 编 制 张国唯 PREPARE _______________________________ 校 对 CHECK _______________________________ 审 定 ______________________________ CONTENT 目录 1 Purpose 目的 2 用途以及范围 Responsibility 责任 4 Control Procedure 控制程序 4.1 Measurement tools 测量工具 4.2 Description of Reference line/Work point 参考线以及基准点的描述 5 Reporting and Documentation 尺寸报告 5.1 Report content 报告内容 Appendix 附件 Appendix 1 Dimension control report template 尺寸报告格式 Appendix 2 Appendix 3 1.目的本方案 2. 用途以及范围 3.1 本方案焊前焊后尺寸测量工作测量工作由船体车间精度控制组，如测量结果超出尺寸公差的要求，需立即向项目 3.2 导缆器的原始测量尺寸在导缆器装配结束后进行，。 3.3 Responsibility 责任 3.1 The responsibility for the initial setting out and alignment controls shall be assigned to personnel from sections as a QC function. (Hull workshop for Hull Structure and Machinery workshop for Machinery portion) 尺寸控制工作的前期开展以及过程的责任要从部门中指派一个固定人员负责In the event that specified dimensions cannot be achieved within certain tolerance, the decision for carrying out remedial works shall be referred to Project technical engineer/Project Manager and QA /QC Supervisor. Any remedial works shall be agreed by DNV and Company prior to the works being carried out 如果有些尺寸不满足规定公差，采取补救措施的决定须向项目主管，项目经理，汇报The dimension control personnel are responsible for the ultimate dimensions from sub-assemblies to the completion of the project. He is also responsible to submit Dimension Control report to QA/QC department for verification 尺寸控制员必须负责项目各阶段的尺寸控制工作并负责向部提交尺寸控制报告以备查 4 控制程序 Control Procedure 4. 1 测量Measurement tools 本项目将会用到以下测量工具The following tools will be used in this project. a．Measuring Tape b，钢直尺 Ruler c，钢丝若干 备注：整个测量过程中尽量使用同一把钢尺和卷尺测量。 4.2 参考线以及基准点的描述 Description of Reference line/Work point 4.2.1 导缆器上半部分监测点示意图： L1,L2为前后控制点 L3,L4,L5,L6,L7,L8 为左右控制点 H1~H4为上下控制点4.2.2 导缆器下半部分监测点示意图： L1,L2为前后控制点 L3,L4为左右控制点 H1~H8为上下控制点