ZC301摄像移植.docVIP

摄像头驱动的移植（ZC3XX）FS2410开发板上移植的是Linux-内核，USB及CS8900A均能工作gspcav1tar.gz： ( 1 ) 在 linux-/drivers/usb 目录下新建 media 目录，将gspcav1tar.gz copy 到 media 下并解压。为了使media 编译进内核，需修改linux-/drivers/usb 目录下的Kconfig、Makefile 文件。 具体操作： [linux@weijing usb]$ vi Kconfig 添加下面语句： source drivers/usb/media/Kconfig [linux@weijing usb]$ vi Makefile 添加下面语句： obj-$(CONFIG_USB_SPCA5XX) += media/ ( 2 )为添加 gspcav1编译选项，在 media 下新建 Kconfig、Makefile 文件。 [linux@weijing media]$ vi Kconfig # # USB Multimedia device configuration # comment USB Multimedia devices depends on USB config USB_SPCA5XX tristate USB SPCA5XX Sunplus/Vimicro/Sonix jpeg Cameras depends on USB VIDEO_DEV ---help--- Say Y or M here is you want to use one of these wedcams: The built-in microphone is enabled by selecting USB Audio support. This driver uses the Video For Linux API.You must say Y or M to Video For Linux(under Character Devices)to use this driver. Information on this API and pointers to v41programs may be found at. To compile this driver as a module,choose M here:the Module will be called spca5xx. “ 帮助文档说明了下面这句话： M USB SPCA5XX Sunplus/Vimicro/Sonix jpeg Cameras ” 特别注意：所在在一移植的时候也要注意看看帮助文档 [linux@weijing media]$ vi Makefile # # Makefile for USB Media drivers # obj-$(CONFIG_USB_SPCA5XX) += gspcav1 ( 3 ) 修改 gspcav1的 Makefile [linux@weijing gspcav1$ vi Makefile gspca-objs := gspca_core.o decoder/gspcadecoder.o obj-$(CONFIG_USB_SPCA5XX) += gspca.o 第三：打ZC301摄像头的补丁usb-2.6.12LE06.patch.tar.gz LINUX内核中系统中没有ZC301P摄像头驱动，要下载对应的内核补丁,其补丁和驱动在http:mxhaard.free.fr中有对应的驱动下载。此处用到的是usb-2.6.12LE06.patch.tar.gz，补丁下载地址http://mxhaard.free.fr/spca50x/embedded/KernelPatch/usb-2.6.12LE06.patch.tar.gz。此patch是为令重编内核时，有spcaxx系列摄像头的支持。把它复制到driver/usb下,解压,打补丁.linux-/drivers/usb tar -xvzf usb-2.6.12LE06.patch.tar.gz patch -p1 usb-2.6.12.patch 第四：编译内核Device Drivers --- Multimedia devices --- * Video For Linux USB support --- * Support for Host-side