10KV配电室装作业规程.docVIP

雅安市伍鑫煤业有限公司水洪林三号井 10KV配电室安装作业规程 编制：杨定君 二00八年七月 10KV配电室安装作业规程 工作任务慨述 1、矿井所在矿区现有一趟雨城区城南供电所KV电源，另设一回南电公司KV线路至变电站，采用双回路供电。由于矿井开采初期主要用电设备距主平硐口的距离不超过1000米，因此矿井暂不设井下变电所，直接由低压0V入井供电。进入二、三采区后，由于供电距离增加，在考虑由高压下井，井下设采区变电所。根据设计要求及矿煤层赋存情况和埋藏条件，矿设计采用分区对角抽出式通风。 开采一采区时利用设计的+1480m回风平硐布置风机抽风，原+1442m平硐及设计的+1400m平硐联合进风。+1480m风井为一采区（硬炭采区）服务，服务年限2.5年、）高低压线路始终端杆均装设避雷器，建筑物、构筑物均按规定装设防雷设施，各电器设备均作保护接地。 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not