2012年四川政法干警考试试题解释及下载.docVIP

2012四川省政法干警考试试题及解析下载2012年河北省基层政法干警考试公告 考试真题 真题解析 在线估分 面试名单下载 复习备考资等考试信息资料，河北省政法干警考试真题 真题解析等最新资料详情点击：/news56494.html??预祝大家考出好成绩。 stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surface dont and stator iron core coil collide; generator stator Reed end set two people guardianship, guardianship generator rotor not and stator core coil collide friction. Slow journey to move into the direction of the rotor, rotor wear them into the stator bore, will contact steam-side slider on the arc skateboards (must be over ladder after the stator to the slider, slider is only allowed access to