4M的ami的ios如何修改.docVIP

最近一些朋友总是在问4M的ami的bios如何修改，尤其是以微星为典型代表的，特制作一个图文教程，一些经验和大家交流。 1、4m的BIOS用ami工具无法直接打开 错误提示： 其实我们只要把最后的2m分离出来修改即可，方法如下： 1、打开BIOS，选取最后的2m。 任意位置右键——编辑——定义选块，如图： 选块尾部部分选择文件尾部，如图： 选块起始位置选择文件中部，如图： 即可选中这部分选块，Ctrl+c发现剪贴板内文件大小即是2m，如图： 新建一个空白的文件，大小选择1即可，然后Ctrl+b，保存即提出2m的bios。 添加slic表 A、此时的BIOS直接用超静二方法修改即可，修改方法就不多说了，不懂的可以坛子内自己搜索。 B、需要特别提醒的是此BIOS内含slic模块——f0模块，所以我们只需要把f0模块的不完整的slic表补充完整即可，方法不再赘述。 C、一个很有意思的现象时，原来的f0模块是空的，现在添加slic后，大小居然不变，具体原因不知，还请高手赐教。 把修改好的2mBIOS替换回原BIOS，方法如下： 打开2m的BIOS，Ctrl+a，Ctrl+c 打开4m的BIOS，转到偏移量200000，Ctrl+b，保存即可。 4、验证后的截图： stator. Rotor installed in the stator end upper hangers supports or in the end cap oil parts installed special rotor shaft bracket. (Figure 19) in the stator ring shop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of four rope or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axial-flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best to blade removed, preventing scratches and blades should be well marked. Rotor steam-side back wheel below the shaft or parts installed steam-side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction installed end to end by a horizontal pole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor surface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not less than 500~700mm, lashing wire rope when winding on the rotor and tighten the double baolan slide knot ... 6.4.6.3 rotor wear loaded official hanging up rotor, pendulum are direction Hou will rotor from Reed end level slow wear trance child bore within, wear loaded process stator bore has two people guardianship, and should guarantee steam end guardianship information smooth, ensure rotor surf