lecture3-AbaqusStandard中的非线性分析.pptVIP

Introduction to Abaqus/Standard and Abaqus/Explicit CONVERGENCE TOLERANCE PARAMETERS FOR MOMENT CRITERION FOR RESIDUAL MOMENT FOR A NONLINEAR PROBLEM 5.000E-03 CRITERION FOR ROTATION CORRECTION IN A NONLINEAR PROBLEM 1.000E-02 INITIAL VALUE OF TIME AVERAGE MOMENT 1.000E-02 AVERAGE MOMENT IS TIME AVERAGE MOMENT ALTERNATE CRIT. FOR RESIDUAL MOMENT FOR A NONLINEAR PROBLEM 2.000E-02 CRITERION FOR ZERO MOMENT RELATIVE TO TIME AVRG. MOMENT 1.000E-05 CRITERION FOR RESIDUAL MOMENT WHEN THERE IS ZERO FLUX 1.000E-05 CRITERION FOR ROTATION CORRECTION WHEN THERE IS ZERO FLUX 1.000E-03 CRITERION FOR RESIDUAL MOMENT FOR A LINEAR INCREMENT 1.000E-08 FIELD CONVERSION RATIO 1.00 VOLUMETRIC STRAIN COMPATIBILITY TOLERANCE FOR HYBRID SOLIDS 1.000E-05 AXIAL STRAIN COMPATIBILITY TOLERANCE FOR HYBRID BEAMS 1.000E-05 TRANS. SHEAR STRAIN COMPATIBILITY TOLERANCE FOR HYBRID BEAMS 1.000E-05 SOFT CONTACT CONSTRAINT COMPATIBILITY TOLERANCE FOR P P0 5.000E-03 SOFT CONTACT CONSTRAINT COMPATIBILITY TOLERANCE FOR P 0.0 0.100 DISPLACEMENT COMPATIBILITY TOLERANCE FOR DCOUP ELEMENTS 1.000E-05 ROTATION COMPATIBILITY TOLERANCE FOR DCOUP ELEMENTS 1.000E-05 非线性悬臂梁分析的输出 狡走烃赐享邦孩牵较铭型上预厂光炙终袍说滦旦朴谭寝刽贺擞误涡限豫供lecture3-AbaqusStandard中的非线性分析lecture3-AbaqusStandard中的非线性分析 Introduction to Abaqus/Standard and Abaqus/Explicit TIME INCREMENTATION CONTROL PARAMETERS: FIRST EQUILIBRIUM ITERATION FOR CONSECUTIVE DIVERGENCE CHECK 4 EQUILIBRIUM ITERATION AT WHICH LOG. CONVERGENCE RATE CHECK BEGINS 8 EQUILIBRIUM ITERATION AFTER WHICH ALTERNATE RESIDUAL IS USED 9 MAXIMUM EQUILIBRIUM ITERATIONS ALLOWED 16 EQUILIBRIUM ITERATION COUNT FOR CUT-BACK IN NEXT INCREMENT 10 MAXIMUM EQUILIB. ITERS IN TWO INCREMENTS FOR TIME INCREMENT INCREASE 4 MAXIMUM ITERATIONS FOR SEVERE DISCONTINUITIES 12 MAXIMUM CUT-BACKS ALLOWED IN AN INCREMENT 5 MAXIMUM DISCON. ITERS IN TWO INCREMENTS FOR TIME INCREMENT INCREASE 6 CUT-BACK FACTOR AFTER DIVERGENCE 0.2500 CUT-BACK FACTOR FOR TOO SLOW CONVERGENCE 0.5000 CUT-BACK FACTOR AFTER TOO