siei变频器参数设置一览表(oh5000).docVIP

SIEI变频器参数设置一览表（OH5000） 以1.75m/s，载重1000kg，平衡系数45%，变频器22kw，电动机14kw 13VTR为例 菜单/参数 设定值 备注 菜单/参数 设定值 备注 Starup/Regulation mode/ /Speed reg gains/ Regulation Mode Brushless SpdP1 gain % 10.00※ % SpdI1 gain % 0.50※ % Starup/Starup config/setup mode/Drive data/ SpdP2 gain % 15.00※ % Main voltage 400/380 V Default SpdI2 gain % 0.50※ % Ambient temp 40 度 Default SpdP3 gain % 20.00※ % Switching freq 8 k Default SpdI3 gain % 2.00※ % Spd ref/fbk res 0.03125 Spd 0 enable Enable as start Setup mode/Motor data/ SpdP3 gain % 40.00※ % Rated voltage 380 V 主机参数 SpdI3 gain % 20.00※ % Rated current 23 A /Speed thresholds/ Rated speed 150 rpm Spd 0 ref thr 1 rpm Pole pairs 10 Spd 0 ref delay 500 ms Torque constant 26.260 Nm/A SGP tran21 h thr 96.00※ % EMF constant 15.162 V*s SGP tran32 I thr 6.00※ % Stator resist 0.5030 % SGP tran 21 band 5.00※ % LsS inductance 0.01414 H SGP tran32 band 4.00※ % Startup/Startup config/Mechanical/ /Pre-torque/ Travel units sel Millimeter Pre-torque src An inp 1 output Gearbox ratio 2 /Ramp function/ Pulley diameter 450 mm Ramp out enable Disabled Full scale speed 150 rpm REGULATION PARAM/Spd regulator/Spd regulator base value /Weights/ SpdP base value 18.00 A/rpm Cabin weight 1200※ kg 根据P、Q情况酌情调整 SpdI base value 1149 A/rpm/s Counter weight 1650※ kg /Digital inputs/Std digital inps/Std dig inp cfg/ Load weight 1000 kg 额定载重 DI 3 inversion Inverted 接触器反馈反相 /Landing zone/ Di 4 inversion Inverted 检修信号反相 Landing control Disable /Digital inputs/Exp digital inps/Exp dig inp cfg/ Landing init src / DI 0X inversion Inverted 1LS反相 Landing distance / DI 1X inversion Inverted 2LS反相 Pos speed limit / DI 2X inversion Inverted 抱闸反馈反相 /Encoders config/ /Digital inputs/Exp digital inps/Exp dig inp en/ Speed fbk sel Std encoder Exp dig inp en Enable Std enc type SinusoidalSinCos /Digital outputs/Std digital outs/Std dig out src/ Std enc pulses 2048 ppr DO 0 src Drive OK 端子80