Telescope.ppt

WIRTH_Pr?s_00.01 WIRTH Group – Telescope Shield Overcut – Changing cutters WIRTH Group – Telescope Shield TECHNICAL SPECIFICATION, TB 570 E/TS Machine model TB 619 E/TS Type Telescope Shield Bore diameter 6,19 mm Total installed power 2790 kW Total weight of basic TBM approx 450 t Weight of back-up (1-stroke) approx. 250 t Length of TBM, face to end of tail approx.12,5 m Length of TBM with back-up (1-stroke) approx.130 m ? Cutter head: Bore diameter with new discs: 6,19 m Bore diameter with max. wear of gauge cutters: 6,16 m Over cut for gauge cutters, change 50 mm (in radius) Over cut standard at crown 55 mm at invert 15 mm Nominal spacing: 80 mm (approximately) No. of cutters per track: 1 centre and face 2 pre gauge track 3 gauge track Reamer cutters 1 unit Nozzles approx. 19+ 1x EDZ, WIRTH Group – Telescope Shield Cutter head drive Power: 6 X2 86=1716 kW Drive type: infinite variable Frequency Drive Rotational speed: 0-7,8 RPM Torque at 3,9 rpm (50 Hz): 4000 kNm Torque at 7,8 rpm (66 Hz).: 2000 kNm (nominal speed) Break out torque 5200 kNm Telescope Section No. of telescope cylinders 14 Max. thrust (490 bar) 25,000 kN Cylinder stroke (Segment 1,5 m) 1,650 mm Operating pressure 490 bar ? Gripper Shield No. of cylinders 2 Total effective gripper force 45,000 kN Ground pressure 4 MPa. ? Rear shield Total pushing force 34,000 kN WIRTH Group – Telescope Shield Cutter Type back loaded Cutter diameter: 432 mm Number of cutters: Centre 6 face 36 gauge 3 nominal load 250 kN Number of reamers: 1 Kerf spacing: approx. 80mm Cutter bearing: taper roller bearing, 2 units Sealing: two-ring friction seal (steel) Lubrication: oil with additives Equipment for changing cutter: 1 unit for centre cutter 1 unit for face and gauge cutter All cutter types back-loading version. Belt Conveyor of TBMBelt width: 800 mm Carrying capacity: 700 m3/h Running speed: 0 – 2