E26_高处作业级_2008 (英文翻译).docVIP

Classification of work at heights 1 Scope This standard specifies the terms and definitions of work at heights, the height calculation method and classification of work at heights. This standard applies all types of work at heights. 2 Normative document reference The following normative document contains provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to, or revisions of, any of these publications (except errata) do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent edition of the normative document indicated herein. For undated references, the latest edition of the normative document referred to applies. GB 3869 1997 Classification on intensity of physical work GB/T 4200 2008 Classified standard of working in the hot environment 3 Terms and definitions The following terms and definitions apply to this standard. 3.1 Work at heights The work performed at a high place greater than 2 meters above the datum plane for highness of falling, where there is a possibility of people falling down from that high place. 3.2 Datum plane for highness of falling The lowest horizontal plane within the possible falling bounds. 3.3 Possible falling bounds The vertical cylindrical space which center is the work position, and which radius is the radius of possible falling bounds. 3.4 Radius of possible falling bounds (R) The horizontal distance to the work position specified in order to define the possible falling bounds. Note: The unit of radius of possible falling bounds is meter, the value depends on the basic highness which is related to the landforms, terrain and distribution of buildings of the work place. The specified value is based on the statistical analysis of a lot of high fall accidents. 3.5 Basic highness (hb) Set a vertical cylindrical space, which center is the work position and which ra