system_LPC11xx.docVIP

system_LPC11xx /**************************************************************************//** * @file system_LPC11xx.c * @brief CMSIS Cortex-M0 Device Peripheral Access Layer Source File * for the NXP LPC11xx/LPC11Cxx Devices * @version V1.10 * @date 24. November 2010 * * @note * Copyright (C) 2009-2010 ARM Limited. All rights reserved. * * @par * ARM Limited (ARM) is supplying this software for use with Cortex-M * processor based microcontrollers. This file can be freely distributed * within development tools that are supporting such ARM based processors. * * @par * THIS SOFTWARE IS PROVIDED AS IS. NO WARRANTIES, WHETHER EXPRESS, IMPLIED * OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF * MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE. * ARM SHALL NOT, IN ANY CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR * CONSEQUENTIAL DAMAGES, FOR ANY REASON WHATSOEVER. * ******************************************************************************/ #include stdint.h #include LPC11xx.h /* //-------- 在下文菜单中使用配置向导 ------------------ */ /*--------------------- Clock Configuration ---------------------------------- // // e Clock Configuration // h 系统振荡器控制 (SYSOSCCTRL) // o1.0 BYPASS: System Oscillator Bypass Enable // 0 振荡器未被旁路 // 1 振荡器被旁路，PLL 输入（sys_osc_clk）直接由管脚XTALIN 和 XTALOUT 提供 // o1.1 FREQRANGE: System Oscillator Frequency Range // i 决定低功耗振荡器的频率范围 // 0= 1 - 20 MHz // 1= 15 - 25 MHz // /h // // h 看门狗振荡器控制寄存器 (WDTOSCCTRL) // o2.0..4 DIVSEL: 选择将 Fclkana 分频成 wdt_osc_clk 的分频器 // i wdt_osc_clk = Fclkana/ (2*(1 + DIVSEL)) // 0-31 Fclkana=2、4、6...64 // o2.5..8 FREQSEL: 选择看门狗振荡器模拟输出频率 (Fclkana) // 0= Undefined // 1= 0.5 MHz // 2= 0.8 MHz //