4.5.1.3-Insulation for Piping.docVIP

4.5.1.3 Insulation for Piping and Equipment 4.5.1.3.1 Scope of Work (1) All piping and equipment of which the inner fluid temperature is over 500C shall be insulated by insulation, brickworks, refractories, lagging and jacketing. (2) The insulation for piping and equipment shall include the following. (a) Insulation, jacketing and lagging (b) Refractory (c) Brickwork (d) Personnel safety insulation (e) Anti-sweat insulation (3) The Bidder shall furnish the tools, scaffolding, cleaning materials and all other pertinent required to satisfactorily complete the work. (4) All piping of which the outer temperature may reach above 50 °C shall be provided with personnel safety insulation. (5) The following piping and those portions located within the following specific areas shall be insulated unless otherwise specified. (a) Exhaust and drain piping of safety and relief valves (b) Exhaust and drain piping of blowdown tank (c) Sampling piping (d) Air compressor outlet air piping up to after cooler (e) Vent and drain piping for auxiliaries (f) Air preheater washing water piping (g) Horizontal piping of the above, where the underside of the pipe is lower than two (2) meters above floors and platforms. (h) Those portions of vertical piping of the above, which is lower than two (2) meters above floors and platforms (i) Horizontal piping of the above whose centerline is within one (1) meter of any normal walkway of platforms and floors. (6) As the dryer is a freezing type, anti-sweat insulation shall be provided for control air outlet piping by applying felt and asphalt paper or other suitable material and shall be provided with jacketing or lagging. (7) The Bidder shall supply a spare quantity of insulation material in consideration of shipping damages or other damages during construction. (8) The Bidder shall protect insulation materials at the site to ensure safe storage and water proofness. (9) The Bidder shall, before material prepar