毕业设计(论文)-基于DS18B20的多路温度检测系统的设计与实现.docVIP

辽宁科技大学本科生毕业设计 第 PAGE V 页基于DS18B20的多路温度检测系统的设计与实现摘要为了达到测量和检测多处温度值，就要求主系统连接多个温度传感器，由于主系统和配件之间连接器上的空闲引脚通常极为有限，要想在不增加连接器复杂度和成本的条件下给系统增加外设识别和控制功能就成为一项极具挑战性的任务。作为拥有1-Wire的DS18B20器件能够满足这些要求。本设计采用多个DS18B20连接在于同一条单线总线上，这可以在许多不同的地方放置多个DS18B20温度传感器进行温度检测。通过用单片机来实现对多个DS18B20的控制，从而实现温度检测，实现报警。显示部分采用了七段数码显示管进行显示，可同时对时间和温度进行显示方便观察。键盘通过对89C51的P1口直接编程来实现。关键词：1-Wire；串行总线;七段数码显示管；温度测量The design and implementation of the multi-temperature detection system based on DS18B20AbstractIn order to achieve measurement and testing various temperature，It requires the main system linked to a number of temperature sensors，As the main system and accessories between the connector pins are usually very limited spare， not to increase the connector complexity and cost of the conditions to increase the peripheral system to identify and control has become one of the greatest challenges of task.As with 1 - Wire the DS18B20 device can meet these requirementsThis design uses a number of DS18B20，what connected with a one-way bus，which can in many different places at various DS18B20 temperature sensor to detect temperature.To achieve through the use of multiple DS18B20 control， thus realizing the temperature detection，and alarm. Demonstrate a part having adopt seven section of digital display tube to carry out the convenient observation demonstrating， but carrying out display on time and the temperature at the same time.89C51 keyboard through the P1 port direct programming to achieveKey words: 1-Wire; Serial Bus ; Seven section of digital display tube; temperature survey 目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc202223491 摘要 PAGEREF _Toc202223491 \h I HYPERLINK \l _Toc202223492 Abstract PAGEREF _Toc202223492 \h II HYPERLINK \l _Toc202223493 1 绪论 PAGEREF _Toc202223493 \h 1 HYPERLINK \l _Toc202223494 1.1 概述I2C总线的应用 PAGEREF _Toc202223494 \h 1 HYPERLINK \l _Toc202223495 1.2 概述单总线的应用 PAGEREF _Toc202223495 \h 1 HYPERLINK \l _Toc202223496 1.3 本设计的结构安排 PAGEREF _Toc202223496 \h 2