毕业设计(论文)－基于PROE离心泵叶轮三维建模及流场数值模拟分析.docVIP

摘要 本文将曲面造型与数值计算有机的结合在一起应用到离心泵叶轮的设计中。采用二维造型得到计算区域，通过对离心泵叶轮内部流场的数值计算与分析，得到较好的离心泵叶轮。 本文主要对离心泵叶轮的计算公式进行研究，并对离心泵叶轮的尺寸进行计算。建立了一个叶轮轴面投影图，为叶轮的绘型做准备。选择一种适合的绘型方法，完成离心泵叶轮的绘型。最后再利用PRO/E软件建立离心泵叶轮的三维实体模型,即完成了在PRO/E中的三维建模。 为了方便流场数值的模拟分析，使用Gambit软件对所得的三维模型进行划分网格，运用fluent软件做出边界条件并计算，再使用fluent软件对所设计的离心泵叶轮内三维流场进行了数值模拟，并对计算结果进行了分析。而后采用基于标准k一e湍流模型来求解，在非结构化网格中，采用基于有限元的有限体积法对方程进行离散，用压力校正法进行数值求解。利用湍流模拟结果，分析了离心泵叶轮进口边位置对泵性能的影响。由于采用了多种求解方法和多重网格加速收敛技术，因而fluent能达到最佳的收敛速度和求解精度。 本文结合实例和经验，通过对离心泵叶轮CFD计算结果的分析，说明所设计的叶轮是成功的。 关键词：离心泵叶轮；PRO/E；三维建模；数值模拟；计算流体动力学（CFD） Title Based on PRO / E centrifugal impeller three-dimensional modeling and numerical simulation Abstract This article will surface modeling and numerical computation applied to the organic combination of centrifugal pump design. Be calculated using two-dimensional modeling area, through the centrifugal pump impeller Numerical calculation and analysis, get a better pump impeller.  In this paper, the formula for centrifugal pump impeller to study, and calculated the size of centrifugal pump impeller. The establishment of a leaf axle plane projection, the drawing of the impeller to prepare. Select the drawing of a suitable method to complete the drawing of centrifugal pump impeller. Finally, using PRO / E software to establish the three-dimensional solid model centrifugal pump impeller, which was completed in PRO / E in the three-dimensional modeling.  In order to facilitate numerical simulation analysis,the use of proceeds Gambit software mesh three-dimensional model,using fluent software to make the boundary conditions anf calculate,and then use software designed for fluent centrifugal pump impeller flow field is numerically simulation and calculation results are analyzed. Then based on the standard k a e turbulence model to solve, in the unstructured grid, finite element based finite volume method to discretize the equations using the numerical solution of the pressure correction method. Turbul