培训课件_SureScan技术介绍.ppt

* The MRI SureScan programming screen automatically appears and MRI SureScan is ON but NOT programmed. To continue you must select the MRI SureScan Pacing mode. Touch the Mode programming field to continue, and to advance the slide. * The MRI mode choices automatically appear. You must select DOO, VOO or AOO ( asynchronous modes I.E. modes that provide pacing but no sensing) or ODO ( a mode that provides sensing but NO pacing – essentially the pacemaker is OFF). Some information to help make the appropriate mode: Pacing percentage counters Rate histograms and Patient’s indication for pacing Perform an Underlying Rhythm Test For patients with an adequate underlying rhythm and no evidence of heart block, consider ODO. For others consider asynchronous pacing for the duration of the scan. Let’s assume we’ve been instructed by the attending cardiologist to use the DOO mode. Touch the DOO field to be automatically directed to the next programming screen (and to advance the slide) * Choosing a Mode will automatically advance you to the next screen. Note your mode choice (DOO) populates the Mode field. Since we have selected an asynchronous mode we must also choose a pacing rate. Had we selected ODO, the Rate (and other fields would not appear). On our screen above note the AV delay fields, and Pacing Output fields are automatically populated. These are non-programmable parameters during SureScan operation. Touch the MRI Lower Rate programming field to access your rate choices (and to advance the slide). * The rate choices are from 30 PPM to 120 PPM in 5 PPM increments. Consider choosing a rate that overdrives the patients intrinsic rate , if one exists. Let’s assume we’ve been asked to program a rate of 80PPM. Touch 80 on the screen to populate the ate field and advance the slide. * All that remains is to touch Program to complete the steps * SureScan is now operational. Note the Mode in the upper left corner, the Therapy/Detection and MRI messages and an