接收.docVIP

接收 #include reg52.h #include intrins.h typedef unsigned char uchar; typedef unsigned char uint; //****************************************NRF24L01端口定义*************************************** sbit MISO =P1^3; sbit MOSI =P1^4; sbit SCK =P1^2; sbit CE =P1^1; sbit CSN =P1^5; sbit IRQ =P1^6; //*XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX uint ge=0,shi=0,bai=0,qian=0,wan=0,shiwan=0,baiwan=0,qianwan=0; uchar code a[10]=0123456789; uchar code b[12]=YuHaoDianZi; sbit RS=P2^0; sbit RW=P2^1; sbit EN=P2^2; void delay1(uint z) //延时函数 { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void zhi(uchar zhiling) //送指令函数 { RS=0; RW=0; P0=zhiling; delay1(20); EN=1; //lcd1602程序 delay1(20); EN=0; } void shu(uchar shuju) //送数据函数 { RS=1; RW=0; P0=shuju; delay1(20); EN=1; delay1(20); EN=0; } void chu() //LCD初始化 { RS=0; RW=0; EN=0; zhi(0x38); //16×2显示，5×7点阵，8位数据接口 zhi(0x0c); //无光标，光标不闪烁0x0c 0x0d zhi(0x06); //写入数据后光标右移一位 zhi(0x01); //清除屏幕以前的数据 } void pos(m) { zhi(0x80+0x40+m); } //XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX //XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX #define TX_ADR_WIDTH 5 // 5 uints TX address width #define RX_ADR_WIDTH 5 // 5 uints RX address width #define TX_PLOAD_WIDTH 20 // 20 uints TX payload #define RX_PLOAD_WIDTH 20 // 20 uints TX payload uint const TX_ADDRESS[TX_ADR_WIDTH]= {0x34,0x43,0x10,0x10,0x01}; //本地地址 uint const RX_ADDRESS[RX_ADR_WIDTH]= {0x34,0x43,0x10,0x10,0x01}; //接收地址 //***************************************NRF24L01寄存器指令**