kilavi建筑物控制平台.pptVIP

CASE 1: single hop Kilavi First, network size effect on communication reliability is tested. There are the master and 4 to 28 sensors in the network. Fig. 5 shows that when traffic rate is under 5 packets per minute per node, 95% reliability is achieved with 28 sensor nodes, 98% with 12 nodes, and 100% with fewer than 8 nodes. Next, packet size effect on reliability is studied. In this case KilaviB packet is progressively increased payload length of Fig. 6 indicates that when traffic rate is under 5pkts/min/node,packet size has no significant effect on reliability. When traffic rate is raised to 30pkts/min/node, the reliability of a 12-node network improves from 90% to 94% as data payload decreases from 512 to 32 bits. Thus, packet size has some effect on reliability even at moderate traffic conditions Modulation used in Kilavi prototypes is simple BPSK(二进制相移键控). Next, modulation method(GMSK-高斯最小频移键控, FSK-频移键控and BPSK) effect is tested on Kilavi reliability.Fig. 7 shows that in low traffic there are no significant differences between these methods. However, when traffic rate is increased to 30pkts/min/node, the reliability is 90% with FSK, 95% with GMSK and 97% with BPSK. Thus, used modulation method proved to be effective. Fig. 8 indicates that when traffic rate is under 5pkts/min/node, over 98% reliability is achieved with all simulated packet sizes. When traffic rate is raised to 30pkts/min/node network reliability decreases from 96% to 87%, as the payload size increases from 32 to 512 bits. Thus, even in a small network, packet size has a strong influence on packet losses. Then, data rate effect on reliability is examined. The network topology is the very same as in packet size simulation above. Fig. 9 indicates that when traffic rate is under 10pkts/min/node, data rate affect reliability only marginally if data rate is at least 25kbps. When traffic rate is increased to30pkts/min/node, the reliability improves from 94% to 97% as the data rate is raised from