數字信号处理—基于计算机的方法第5章答案.docVIP

PAGE 1 PAGE 22 5-1 An AM broadcast transmitter is tested by feeding the RF output into a 50-? (dummy) load. Tone modulation is applied. The carrier frequency is 850 kHz and the FCC licensed power output is 5,000 W. The sinusoidal tone of 1,000 Hz is set for 90% modulation. (a) Evaluate the FCC power in dBk (dB above 1 kW) units. (b) Write an equation for the voltage that appears across the 50-? load, giving numerical values for all constants. (c) Sketch the spectrum of this voltage as it would appear on a calibrated spectrum analyzer. (d) What is the average power that is being dissipated in the dummy load? (e) What is the peak envelope power? Solution： (a) FCC power: (c) SHAPE \* MERGEFORMAT (d) (e) 5-2 An AM transmitter is modulated with an audio testing signal given by , where ,,and . Assume that the AM signal is fed into a load. (a) Sketch the AM waveform. (b) What is the modulation percentage? (c) Evaluate and sketch the spectrum of the AM waveform. Solution: 5-4 Assume that an AM transmitter is modulated with a video testing signal given by ,where f1=3.57MHz. Let Ac=100. (a) Sketch the AM waveform. (b) What are the percentages of positive and negative modulation? (c) Evaluate and sketch the spectrum of the AM waveform about fc. Solution: 5-5 A 50,000-W AM broadcast transmitter is being evaluated by means of a two-tone test. The transmitter is connected to a 50-? load, and , where f1=500 Hz. Assume that a perfect AM signal is generated. (a) Evaluate the complex envelope for the AM signal in terms of A1 and ?1. (b) Determine the value of A1 for 90% modulation. (c) Find the values for the peak current and average current into the 50-? load for the 90% modulation case. Solution: (a) (b) to find [m(t)]min : x(?) = cos? +cos2? (c) ∴ 5-12 SSB signals can be generated by the phasing method shown in Fig. 5-5a, by the filter method, of Fig. 5-5b, or by the use of Weaver’s method [Weaver, 1956],