塑胶模具邮件英语.docVIP

1.Please find the revised drawing for your final approval. 请批准修改后的图纸。 2.Since the draft angle was changed, we need to lower the parting line for the mold. 由于角度改变，模具分型处要降面。 3.please Provide the information of the injection machine to me. 请提供注塑机资料给我们。 单词：1.approval:批准 2.lower:降低 3.injection machine:注塑机 4.please provide the shrinkage of the resin. 请提供胶料的缩水率 5.The preliminary mold design has been completed and will send to you later today. 初步的设计已完成，今天将传给你。 6.Please confirm that the sink mark is acceptable. 请确认缩水痕是否可接受。 单词：shrinkage 缩水率；preliminary 初步的；sink mark 缩水痕 7.Could you please let me know the location of the edge gate? 能告诉我侧浇口位置吗？ 8. Please make sure these numbers will be engraved on the core block of the mold. 请记的把这些符号雕刻在下模仁上。 9.The part number needs to be polished and recessed the surface of the part. 产品编号处要抛光，并要凹入产品表面。 单词：edge gate 侧浇口; engrave 雕刻 ; recess 凹入 10.Pls enlarge the gate dimension to Dia 1.1mm . 进胶口加大到直径1.1mm. 11.I am still a little concerned about the weakness of the weld line. 我依然很关心烧焊处的强度。 12.We need to get your confirmation to order the hot manifold system 我们须得到你的确认后，定购热流道系统。 单词：enlarge 加大; weld 烧焊; hot manifold system 热流道系统 13.We have added 2 undercuts to this part to eliminate the sticking problem. 为防粘模，我们已在零件中加了两处倒扣。 14.We consider that the cooling function of our current design will be better and more sufficient than former design . 我们认为现有的冷却系统设计比原先更充分。 15.we will add one ejector pin beside the boss to avoid ejector marks. 为防顶白，我们将在柱位旁加一顶针。 单词：undercut 倒扣; sufficient 充分的; ejector mark 顶白 16.The only thing we can do is to make sure every steel dimension within tolerance. 我们要做的是使每一个钢料尺寸在公差范围内。 17.Can you send me the molding parameter used when you running the part? 能提供生产产品时使用的成型参数吗？ 18.the red surface indicated no draft, we suggest to add two degree as other surfaces, please confirm. 红色面显示无出模角，我们建议加2度出模角，请确认。 单词：tolerance 公差; molding parameter 成型参数; draft 斜度 19.We believe that the production tool parts will