常用的表面处理介绍.ppt

After electroless nickel are the electroplating steps. It starts with nickel strike and then acid copper, multilayer nickel and bright chrome. The second step is to mount the parts on the racks. These are the points to take good care. Otherwise, again, this will give poor adhesion. The first step of plastic pretreatment is the chrome etch. The bath contains chromic acid and sulphuric acid. High temperature and various immersion time depending on the surface conditions of the plastics – 6 to 20 minutes. * If the surface is evenly etched, it will leave holes which are small but evenly distribute