自动化专业本科毕业设英文翻译.docVIP

自动化专业本科毕业设计英文翻译 学院(部)： 专业班级： 学生姓名： 指导教师： 2012年 6 月 3 日 THE PLC-BASED BOILER COMBUSTION C ONTROL SYSTEM 1 Introduction Combustion control system is the master of the power plant boiler system, which including a fuel control system, air flow control system, and furnace pressure control system. Most of the power plant boiler combustion control system is still using PID control. Combustion control system by the main steam pressure control and the burn rate control to form a cascade control system, in which the combustion rate control is controlled by the amount of fuel, air volume control, cited air volume control constitute. Each sub-control system is respectively, and through the different measurement can control methods to ensure economic burning combustion and safety. 2 The control program Boiler burning the basic task of the automatic control system is to make fuel combustion, so that can provide heat to adapt to the requirements of the boiler output steam load. But it must to ensure the safe and economic operation of the boiler. A boiler fuel, air supply and bleed air volume control of the three tasks are not separate. These three control variables can be controlled with three controllers, but each other should be co-coordinated in order to work reliably. To set the water temperature, you need to adjust the blast volume and the proportion in the amount of coal to the boiler running at optimum combustion state. When the furnace memory at a certain negative pressure, it can maintain the boiler thermal efficiency and avoid the outward flame of the furnace overheated in order to ensure the safety of personnel and environmental hygiene. 2.1 The control system in the overall framework of design Combustion process automatic control system the program and the type of boiler equipment, operation and control requirements, it related to the different circumstances and requirements. Unit power plant combustion process controlled objec