本科毕业设计--近期10万远期20万给水厂.doc

苏北某市新区水厂工艺设计 扬州大学 给水排水工程专业 2011届 学生姓名：孙秀秀 指导老师：乔庆云 中文摘要 本设计为苏北某市新区水厂工艺设计。该工程设计规模为20万m3/d，以古黄河为水源其中近期工程为10万m3/d，远期工程为10万m3/d。 要求根据所给资料进行给水工艺设计、单体构筑物的设计计算，包括取水输水构筑物设计、净水厂设计和制水成本计算。 根据原水水质基本符合国家《地表水环境质量标准》（GB3838-2002）Ⅲ类水体，出厂水水质要求达到《生活饮用水卫生标准》（GB5749-2006）的要求,通过经济技术比较，确定净水厂的工艺流程选用方案一： 原水—→一级泵房—→管道静态混合器—→网格絮凝池—→平流沉淀池—→V型滤池 ↑混凝剂 —→清水池—→吸水井—→二级泵房—→配水管网。 ↑氯消毒 关键词：苏北某市新区；给水工程；取水构筑物；工艺流程；净水构筑物 Abstract The design is water supply project for a newly developed area in North-Jiangsu with the total volume of 20 thousand cubic meters, for the water to the ancient Yellow river, the recent 10 thousand cubic meters, Long-term10 thousand cubic meters. According to the given information, technology design and water monomer structure design are required; water intake structures, water purification plant design and water costs are also included. According to “Surface Water Environmental Quality Standards” (GB3838-2002) Ⅲ raw water quanlity, and water plant to meet water quality requirements Drinking Water Health Standards (GB5749-2006), Two sets of programmer have been compared both technologically and economically. And the first programmer is preferred. The whole process is as follows: ↓ coagulation raw water—→primary water pumping station—→pipe-shaped—→grid flocculation tank ↓ disinfection —→horizontal-flow sedimentation basin—→V-filter—→storage pool—→water well—→secondary water pumping station—→urban pipe network. Key word: A newly developed area in North-Jiangsu; Water supply engineering; Water intake structures; process; Water structures. 目 录 绪 论………………………………………………………………………….5 1. 概 况….……………………………………………………………………6 1.1 自然概况………….…………………………………………………….6 1.2 供水现状及规划………………………………………………………..7 2. 供水方案设计……………………………………………………………….7 2.1 水源选择………………………………………………………………..7 2.1.1 水源选择原则…………………………………………………….7 2.1.2 水源的选择……………………………………………………….8 2.2 取水