滑模a施工方法.docVIP

MS001 DATE 05/5/08 Method Statement For : Excavation less than 2 meters Owner : Lafarge Contractor: CBMI Establi Safety manager: Owner Approve(Site Manager) : □yes □yes with comment NO Safety Manager : □ yes □yes with comment □NO Work title: Slipform construction 工作名称：滑模 The method statement includes: slip form work for cement silo 包括:水泥库滑模。 Description:（说明） Explanation of the process（过程说明） Surveying测量放线 Foundation construction have been finished 基础部分施工 Revise the reinforcement 钢筋绑扎效正 Fixing and aligning brackets支承开支架组对调平 Fixing and aligning formwork模板拼装加固、找正 Connecting and laying oil pipes各油路管连接铺设 Fixing board on work platform铺设平台板并固定 Setting up platform for reinforcement and other material. 搭设支承架放钢筋等材料 Fit climbing rod and hydraulic equipment and aligning扒杆就位、液压设备就位效正 Leveling and aligning the whole assembly work platform整体调平、找正 Connect electrical equipment with power电气设备电源连接 Commissioning滑模设备就位调试 Check hydraulic equipment to make sure all the equipments are in good condition ;检查液压设备状态是否良好 Safety induction regarding slip forming works was delivered to operators and other workers, everybody wears the right PPE;安全交底，并穿戴PPE Barricade the working area.安全围护 Set up emergency passage .修建逃生通道上部做防护 Switch on after checking. 检查并合上电闸 Slip form work starting. 滑模正式开始 After going up 2m setting up lower work platform and protect it properly起滑到2米以后下平台搭设并做安全防护 Checking verticality by plumb bob垂直度检查定位、定点并挂好垂球 Checking verticality during the course for acceptance过程垂直度效正检查验收 Transporting material vertically by tower crane材料垂直运输采用塔式起重机提升 Time/duration: daytime（工作时间及期限：白天/晚上） Resources:（资源） Personnel:（人员） Mixer driver (4) （汽车司机4人） Tower crane operator (2) （塔吊司机2人） Crane operator (2) (吊车司机2人) Steel fixer (15) (钢筋工15人/) Mason(25) (混凝土工25人) Carpenter(12) (木工12人) Electrician (1)