2016开模分析报告范本.pptVIP

Plastic Mold Of CMMSG Stamping Tool Developing Division Page * Parting line PL Cavity Core The red line is PL ,please confirm ! Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Page * Texture Area Pattern MT11000 MT11010 MT11020 MT11030 Depth (inch) 0.0004 0.001 0.0015 0.002 Draft suggestion 1.5° 2° 3° 3.5° Red and blue surface:MT11020 please draft the red surfaces from 1.5° to 3° Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Page * Gate location(1) Gate type: Sub gate Gate size: 1x1 Gate Location 1.If the red surface is texture area,the gate will destroy the surface of part. 2. So suggest cancelling the texture of red surface,or approve the proposa 2 (see next page) Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Page * Gate location(2) Gate type: banana gate Gate size: 1x1.5 Gate Location Suggest gate Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Page * Sliders (2) SLIDE-2 There will be a Slide insert in the tool. The red line is the insert _ line , please confirm. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Page * Draft check (2) Core Present Design Suggest Design 0.5° Red surface is undercut, please draft it 0.5° along the core side. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.