dry srinkage of the wall.docVIP

dry shrinkage of the wall caused by the crack A block masonry tools to use Block masonry length according to the wall to block arrangement before, part of the block length need to be cut, cut with a straight edge on the block when cross cutting line first, and then use cutting machine according to the cutting of cutting line, also can use desktop cutting machine for cutting Block horizontal mortar joint application special spatula evenly spread mortar next leather block surface; Available with vertical mortar joint of rabbet block painting iron plate with masonry mortar in the block to a side wall A laying process Before the first leather block masonry pop-up wall position control line, wet with water base, then adjust the : cement mortar laid the first leather block level A laying the first block Laying the first block according to its location on the cement mortar pad first line adjusting and vertical degree, position accurately in the block bottom horizontal mortar joint and side after vertical mortar joint after full coat mortar masonry A laying requirements Masonry block between should push tight, extrusion grout mortar and to achieve the requirement of the masonry with pulp, masonry need level and the rubber mallet keeps the control level and facade verticality A block up and down the skin of masonry lap set requirements Wall in plane and Angle of masonry block up and down the skin should be done when the lap, lap length when the plane masonry generally should not be less than / of the be lap block length, and not less than mm A circular arc wall laying process If the wall arc radius is lesser, block between the vertical mortar joint will be larger, block to the length of the cut, to shrink the vertical mortar joint clearance A eight word wall laying process Up and down on the corner of eight leather block cant pass up and down seam condition A ring beam, beam and constructional column A block masonry wall post setting measures (horse tooth