SYD-201F低温沥青针入度仪.docVIP

SYD-2801F低温针入度试验器 GLMGS 2002年06月06日 一、产品简介 One, product introduction 本仪器是根据中华人民共和国标准GB/T4509《石油沥青针入度测定法》、中华人民共和国行业标准JTJ052《公路工程沥青及沥青混合料试验规程》中的T0604《沥青针入度试验》所规定的要求设计制造的，适用于低温条件下沥青针入度的测试。本仪器也可用于固体细粒、粉剂、胶体、冻体等材料，以及乳酪、糖胶、牛油、麦其淋、奶油、发酵体等食品原料在低温条件下的针入度检验，在食品工业、交通公路工程及其他工业部门都可广泛应用。 The instrument is based on the standards of peoples Republic of China GB / T4509 determination of needle penetration of petroleum asphalt, the peoples Republic of China industry standard JTJ052 highway engineering asphalt and asphalt mixture test procedures in the T0604 asphalt penetration test the requirements of the design and manufacture, is suitable for low temperature asphalt penetration test. The apparatus can also be used for solid particles, powder, colloidal, jelly and other materials, as well as the cheese, sugar, butter, cream, cream of wheat, fermentation, food raw materials at low temperatures the penetration test, in the food industry, highway traffic engineering and other industries are widely used. 二、技术指标 Two, technical indicators 1、恒温水浴参数 In 1, the constant temperature water bath parameters ★供电电源：AC220V±10%；50Hz。 Of power: AC220V + 10% 50Hz. ★浴槽容积：8.5L。 In the bath volume: 8.5L. ★温度范围：5.0~100.0℃。 In the temperature range: 5 ~ 100. ★恒温精度：±0.1℃。 In constant temperature precision: 0.1 DEG c.. ★循环水量：5L/min。 In circulating water: 5L / min. ★水泵扬程：1m。 Lift of pump: 1m. ★ 整机功耗：不大于1000W。 Power consumption: not more than 1000W. 2、针入度仪参数 In 2, the penetration instrument parameters ★针入时控装置：可分别选择5、60秒，时间误差小于±0.1秒。 Of a needle into the time control device: can respectively select 5, 60 seconds, time error is less than 0.1 seconds. ★ 针入深度装置：采用高精度数字显示器，使用方便、快捷、直观，可在任何位置启动。 In depth: needle device using high precision digital display, easy to use, fast, intuitive, can be in any position to start. ★分辨率：0.01㎜； Resolution: 0.01 mm; ★针入精度：±1针入度。 The accuracy of needle into the needle penetration: + 1. ★最大针入深度：600针入度。 The maximum depth of the needle penetration: 600. 三、产品特点 Three, product c