PLC 200 从站库端口1程序.docVIP

因为PLC 224XP 端口0烧了,而眼前又没有CPU,所以改了下这个库程序,在224XP上成功运行;主要是改port 0改为1,然后就是状态字SM全部改为端口1的,可以看帮助,然后就是两个中断改为端口1的,为24和26; 下面是修改好的程序代码: MBUS_INIT.txt MBUS_SLAVE.txt MBUS1.txt MBUS2.txt MBUS3.txt —————————————————————————————————— SUBROUTINE_BLOCK MBUS_INIT:SBR1 TITLE= VAR_INPUT Mode:BYTE; Addr:BYTE; Baud:DWORD; Parity:BYTE; Delay:INT; MaxIQ:INT; MaxAI:INT; MaxHold:INT; HoldStart:DWORD; END_VAR VAR_OUTPUT Done:BOOL; Error:BYTE; END_VAR BEGIN Network 1 Network 2 LD SM0.0 MOVD AC0, LD25 MOVD AC1, LD29 MOVD AC2, LD33 MOVD AC3, LD37 MOVB 0, VB778 NOT FILL +0, VW0, 128 BMD VD256, VD256, 12