第5章安装Cisco设备概述.ppt

Emphasize: Make sure each student has seen a Cat 5 cable. Describe the test for crossover cable determination. If you hold the two ends of an RJ-45 cable side by side, youll see eight colored strips, or pins, at each end. If the order of the colored pins is the same at each end, then the cable is straight through. If the order of the colors is reversed at each end, then the cable is crossed over or rolled. Ethernet uses pins 1, 2, 3, and 6. For crossover, pin 1 is connected to 3, and oin 2 is connected to 6. Crossover cables are used for switch to switch cabling, PC to PC cabling, switch to