Generally the surface of the plaster engineering quality shall meet the following requirements.docVIP

Generally the surface of the plaster engineering quality shall meet the following requirements: 1) ordinary plaster surface should be smooth, clean, if smooth, frame joint should be clear. 2) advanced plaster surface should be smooth, clean, uniform color, no lines, frame joint and grey line should be clear and beautiful. Inspection requirements: plaster level should meet the design requirements. Inspection methods: observation, hand to check. (2) protect horn, holes, slots, plaster around the box should be neat, smooth, pipes behind the plaster surface is flat and level. Inspection requirements, organization of personnel in charge of holes, grooves, around the box and pipe behind the plaster work, should wipe after inspection by quality inspection department, and fill in the acceptance of work record. Inspection methods: observation. (3) rendering should comply with the design requirements, the total thickness of cement mortar shall not be put on the lime mortar, the surface plaster ash shall not be put on the cement mortar layer. Inspection requirements: must be strictly in accordance with the requirements of construction technology during the construction of operation. Inspection method: inspect the construction record. (4) to allow the general plastering engineering quality deviation and inspection methods shall comply with the provisions of the table 4.1.5.2. 6.3.1.6 finished product protection (1) prior to rendering the gaps between the door, window and wall according to the technological requirements to its embedded plug is close-grained, the wooden door, window, iron, wood or wooden frame for protection, should be adopted to plastic or metal door and window sticker protection should be adopted. (2) after the completion of the deal with wall plastering door, window, to clean and protect, door, window, the original cover if there is any damage should be repaired in a timely manner to ensure complete until completion center. (3) in the process of