03-Crescent_former中第3章节.docxVIP

3MAINTENANCE3.1GeneralThis chapter describes the maintenance and upkeep of the CrescentFormer, which is the responsibility of the machine operator.All activities mentioned in this chapter must be performed at the correct time.The ANDRITZ service department is at your disposal for troubleshooting, as well as for extensive maintenance and repair work./INTRODUCTIONRepair work on the plant components must be carried out at the manufacturers works.Workers trained and authorized by ANDRITZ may carry out repairs on site after obtaining consent from ANDRITZ.3.2Safety instructionsDANGERDo not disregard the safety regulations.If the safety regulations are disregarded, this may cause a risk to life and limb and damage to the machine or its components.All safety instructions in this section must be strictly observed!DANGERFrom burns at hot machine components. Risk to life and limb!No maintenance work should be carried out until the hot surfaces have cooled!General safety instructionsAll applicable accident prevention regulations must be observed.Sufficient space for maintenance work must be included right away in the arrangement drawing.Service and maintenance work should not be performed until the tissue machine has come to a standstill and all supply lines have been closed off.Do not exceed permissible crane loads and weights on lifting gear and ropes/shackles. Secure loads against falling from a height.Do not step or walk below suspended loads! Standing below suspended loads can have fatal consequences and thus is strictly forbidden!The machine must be thoroughly cleaned before carrying out any maintenance work.Use only original spare parts.Safety devicesAfter completion of maintenance work, all required safety devices must be mounted again.Power supplyBefore beginning any maintenance or repair work the operator must disconnect the energy supply to all drives securely. This can be achieved with a service switch, lockable racks in the MCC, or with other suitable measures that