C.N-1818 English specification.docVIP

SHEN ZHEN XIAOCAINIAO ELETRONIC CO.,LTD ADD: 1803/B, Seven Star Commercial Plaza,MeiLong Road,Longhua Distrist, Shenzhen city SPECIFICATION MODEL NO.: C.N-1818 REV：X1.0 CUSTOMER: DESCRIPTION: Input:110~240V AC 50/60Hz Output:12VDC2A OUR MODEL NO: SAMPLE NO: DATE: APPROVAL SIGNATURE APPROVED BY CHECKED BY TESTED BY 1. SCOPE The C.N-1818 is a 24 Watts single outputs, universal input switching power supply,, 2. Mechanical requirements 2.1 Power supply Dimension Constraints 88(L)* 45(W)*35(H) mm Note: height include PCB and component lead 3. Electrical requirements 3.1 Input AC 3.1.1 Input voltage Minimum Nominal Maximum 100 110/220 240 Vac 3.1.2 Input Frequency Minimum Nominal Maximum 47 50 63 Hz 3.1.3 Input Current The input current is less than 0.6A @110Vac maxload 3.1.4 Inrush Current The inrush current is 50A max @110Vac, cold start / 25℃ / max load. And first turn on. 3.1.5 Earth Leakage Current The earth leakage current is less than 0.25mA @230Vac. 3.2 Output voltages and loads Table.1 Signal Name Voltage (Volts) Current (A) Min Typ Max Min Max +12V 11.4 12 12.6 0 2.0 3.2.1 The PIN designations and color defined as follows: 3.2.2 Line Regulation The line regulation is less than ?1% 3.2.3 Load Regulation The load regulation is less than ?5% of typical voltage, output voltage show at Table 1 3.2.6 Start up Time : 2 sec max at 110Vac maxload. 3.3 Ripple and Noise 3.3.1 Ripple and Noise required specification Table.2 is the Ripple and Noise limitations of switching power supply under all operating conditions including the input line voltage range and over all the full load range. Please refer to section 3.3.2 for measurement methods.