《NETAPP Cluster存储安装配置指导书》.docVIP

netApp存储安装配置指导书 (------Netapp Cluster 安装配置------) 一：Netapp Fas3020/c Cluster 是由二个ESH模块构成 在各自运行不同应用的前提下 提供相互监控与备份的冗余功能，当一个esh出现软硬故障 另外一个esh接管当前应用的运行直到esh软硬故障解除 手动接管之前的应用既可 以下是cluster 安装配置 可依据data ontap guide 二:cluster的安装 1:输入cluster license Fas3020alicense add ******** 2:Fas3020a机 运行安装命令setup Fas3020a setup Please enter the new hostname [fas200a] Do you want to configure virtual network interfaces? [n]:y Number of virtual interfaces to configure? [0] 1 Name of virtual interface #1 []: vif1 Is vif1 a single [s] or multi [m] virtual interface? [m] m Number of links for vif1? [0] 2 Name of link #1 for vif1 []: e0a Name of link #2 for vif1 []: e0b Please enter the IP address for Network Interface vif1 []: 10.72.3.35 Please enter the netmask for Network Interface vif1 [255.255.0.0]: 255.255.255.0 Please enter media type for vif1 {100tx-fd, tp-fd, 100tx, tp, auto (10/100/1000)} [auto]: Enter Please enter media type for e0a {100tx-fd, tp-fd, 100tx, tp, auto (10/100/1000)} [auto]: Please enter flow control for e0a {none, receive, send, full} [full]: Do you want e0a to support jumbo frames? [n]: Should interface e0a take over a partner IP address during failover? [n]: y The clustered failover software is not yet licensed. To enable network failover, you should run the ’license’ command for clustered failover. Please enter the IP address or interface name to be taken over by e0a []: 10.72.3.36 (节点2fas200b的ip的地址,如果在节点2就写节点1的ip地址相互接管) Please enter the media type for e0a {100tx-fd, tp-fd, 100tx, tp, auto (10/100/1000)} [auto]: Please enter the flow control for e0a {none, receive, send, full} [full]: Do you want e0a to support jumbo frames? [n]: 3: fas3020b机cluster安装 (方法一样只是把另外一台机的ip相互输入成为partner) Fas3020b setup Please enter the new hostname [fas200b] Do you want to configure virtual network interfaces? [n]:y Number of virtual interfaces to configure? [0] 1 Name of virtual interface #1 []: vif1 Is vif1 a single [s] or multi [m] virtual interface? [m] m Number of links f