电感式传感器1学习课件.pptVIP

Constant current source to coil two-way charging of inductive displacement sensor Foreword With no sine signal incentive, only use the switch mode measuring capacitance value to be measured capacitance value below . And there are many capacitive sensors design by this method especially the use of constancy of pressure signal to small capacitance charging usage. Principle of Measurement To be used the switch circuit with constant current source circuit to charge the electrical inductance. Only after diode discharge measurement inductance value principle as shown in figure shows. Constant current source two-way charging Measuring inductor inductance value can be completed in a few seconds, but to make it inductive sensor, the inductance long-term work in a direction of excitation, will appear remnant magnetization and affect the performance of the sensor, more over positive journey and reverse journey are variation considerably. Measure inductance value of the test circuit Measuring the displacement of the test design The test design by measured the displacement as shown in figure below. Homemade coil and skeleton, the coil single around is 160 turn, the long is 20mm. Magnetic bar diameter 8mm ,long 30mm, with strong adhesive in the micrometer mobile stem. Coordinate starting point has no special requirement, only consider displacement and timing gauge numerical N (namely inductance value). Measurement of displacement x is used micrometer drive displacement rod movement and then moving magnet. Every 1mm with bridge measured displacement point of inductance value as standard inductance value, and so to get inductance value and displacement relationship curve as shown in figure Test data analysis The inductance coil received diagram measured inductance , the electric constant current source charge is 100mA, the time of two-way charging and discharging four state each is 500 , to measure displacement x and reading N