MOTOTRBOsystemapp.pptVIP

酒店、物业等楼宇覆盖 成功案例： 国家博物馆、青岛香格里拉酒店、上海国际金融中心QA MOTOTRBO QA Instructor Notes: This slide introduces the two slot TDMA architecture. Refer to Section 2- System Feature Overview of the MOTOTRBO System Planner (T12). Note: Users in Slot 1 cannot communicate with users in slot 2. TDMA thereby offers a straightforward method for achieving 6.25 Hz equivalency in 12.5kHz repeater channels — a major benefit for users of increasingly crowded licensed bands. Instead of dividing channels into smaller slices of decreased bandwidth — which is what would be required to increase spectrum efficiency with FDMA methods, TDMA uses the full 12.5kHz channel bandwidth, but increases efficiency by dividing it into two alternating time slots. Additionally, this method preserves the well-known radio frequency (RF) performance characteristics of the 12.5kHz signal. From the perspective of RF physics — that is, actual transmitted power and radiated emissions — the 12.5kHz signal of 2-slot TDMA occupies the channel, propagates, and performs essentially in the same way as today’s 12.5kHz analog signals. With the added advantages of digital technology, TDMA-based radios can work within a single repeater channel to provide roughly twice the traffic capacity, while offering RF coverage performance equivalent to, or better than, today’s analog radio. Instructor Notes: This slide introduces the concept of two time slots also known as logical channels. Tip: Demonstrate how two calls with the same frequency but different time slots can occur simultaneously. Refer to Section 2- System Feature Overview of the MOTOTRBO System Planner (T12). This is only available in repeater mode. The two time slots or logical channels enabled by 2-slot TDMA can potentially be used for a variety of purposes. Many organizations deploying MOTOTRBO systems can use these slots in the following manner: ? Use both the slots as voice channels. This doubles the voice capacity per licensed repeater channel, thereb