《基于Pro E的手机外壳模具设计与解析 硕士论文》.docVIP

东北农业大学学士学位论文学号：A0基于Pro/E的手机外壳模具设计与解析学生姓名：贺 毅 指导教师：李元强 所在院系：工程学院 所学专业：机械设计制造及其自动化 研究方向：机械设计东 北 农 业 大 学 中国 · 哈尔滨 2015年6月  NEAU Dissertation of Bachelor DegreeNumber:A0 The mould design and analysis of mobile phone shell based on Pro/EStudent Name: He Yi Supervisor: Li Yuanqiang Department and faculty: Engineering instituteMajor:mechanical : Design, manufacturing and automationOrientation: Mechanical design and manufacturingNortheast Agricultural University Harbin·China June 2015摘 要本设计是对华为C8812E手机后盖的注塑模设计并解析。注塑模具是塑件制品最常用的成型模具，因为用注塑模具可以一次性注射成型精密复杂的塑件，可以减少科研开发的投入。本设计都手机后盖注塑模具的设计有详细的过程和介绍，首先对华为C8812E手机后盖造型设计、确定分型面、浇注系统的设计、选择注塑机、再到Pro/E5.0中模架的选取、校核等等，这些过程都有非常细致的说明。在整个手机后盖注塑模具设计过程中主要运用了Peo/E5.0对手机外壳的造型设计和它的EMX模快对模架的选取。而运用Moldeflow软件主要是对浇注系统浇口位置优化、冷却回路优化、注射时压力分析等一系列辅助分析，通过这些分析可以在设计的时候就去不断完善设计，非常大程度上节省了设计周期，提高了效率。通过这次设计，不仅对注射模具设计有了更深的理解，也让学习的知识得到了运用。 关键词: 注塑模 Pro/E 仿真加工 MoldflowAbstract This design is to China for C8812E mobile phone back cover of injection mold design and parsing.Injection mould is one of the most common molding plastic products, because in plastic injection mold can be one-time injection molding sophisticated pieces,can reduce the scientific research and development.This design all mobile phone back cover injection mold design of the detailed process and the introduction, the first in China to C8812E mobile phone back cover design, determine the parting surface, gating system design, the choice of injection molding machine, and then to Pro/E5.0 selection of die set, check, etc., these processes are very detailed instructions.Throughout the cell phone back cover injection mold design process mainly USES the Peo/E5.0 modelling design and its related to mobile phone shell EMX die fast on the selection of die set.On gating system using Moldeflow software mainly gate location optimization, cooling circuit optimization, injection pressure, and a series of auxiliary analysis, through these analysis can be design to improve design, a very large