《基于PSSE的电力系统仿真计算及分析本科生毕业设计》.docVIP

本科生毕业设计（论文）题 目：基于PSS/E的电力系统潮流计算及结果分析姓 名：学 院：电气工程与自动化学院专 业：电气工程与自动化年 级：校内指导教师：（签名）年 月 日基于PSS/E的电力系统潮流计及结果分析 摘要Power flow calculation of power systems and analysis of its results based on PSS/E Abstract Power flow calculation is one of the important means to study power system. Through the power flow calculation, we can calculate the voltage of each node and the power distribution, so that we can check whether the voltage of nodes and current distribution satisfy demand or not. At the meantime, we can analyse the reasonable distribution of power flow. In addition, under the normal maintenance and the special operation mode, we can also through power flow calculation to know that the start-up mode of power plants, so we can make good preparations for contingency and the dropping out of equipments. In order to complete the paper, I need to learn about the power system simulation software PSS/E. Including understanding its various functions, learning to fill data cards, and studying the model of each component. And use PSS/E to simulate a simple example of the book to check out the degree of learning this software. Then I use PSS/E to simulate IEEE39 nodes system. On the basis of success, I analyze that the effect of reactive power on the system voltage, the effect of active power on the system voltage phase angle and the influence of variable ratio on the system voltage. Meanwhile, the economic dispatch of IEEE39 node system is carried out to analyze how to allocate the generator active power, so as to decrease network loss to achieve the effect of economic operation. During this experiment, we use several examples and comparison，and greatly improve the reliability of the experimental results. Finally through the simulation, the experimental conclusion is as follows: By adjusting the power system reactive power can improve system node voltage; I get the relationship between the load of active power and the change of the system voltage phase angle; I