《手提箱提手塑料注射模具设计(全套图纸)》.docVIP

学科门类：单位代码 ：毕业设计说明书（论文） 手提箱提手塑料注射模具设计学生姓名 所学专业班 级学 号指导教师XXXXXXXXX系 二○**年XX月摘要要解决的测绘在模具设计时对分型面的选择、浇口形式与位置的确定、型腔位置的安排、侧抽芯机构的设计、冷却水道的设置该注射模采用了结构。：lastic Injection Mold Design Of Suitcase HandleAbstract The graduation project is the subject of a suitcase handle plastic injection mold design, molding process in accordance with the requirements of the original plastic parts based on the introduction of the injection mold structure, the main points of the die design and working process. First of all, from the plastic manufacturing process to the design of the products of analysis and calculation process, and then calculated based on the analysis and to identify relevant information see Process program, and then on the basis of the total assembly drawing into the die structure design. In theinjection mold based on the size of the main components for the design andcalculation, to be referred to during the plastic molding and a large number of relevantinformation and through a variety of mold design manual, and by calculating the die to determine the specific structure and size, through continuous Calculation and modified, and the teachers careful guidance, care and patience to carry out non-stop, under the guidance of the bills are the final completion of the graduation project independently. In the design process, first of all to solve the mapping handle on the suitcase. In the die design surface on the choice of the gate to determine the form and location, location arrangement cavity, side core-pulling mechanism design, water cooling setup. Spring will be the subject away from the use of screw-type device to ensure that the two points. Because it is low-volume production, the use of an injection mold cavity mode structure of 2. Key words: Injection Mould ；Feed System；Slider ；Side Core Pulling目 录 主要符号表 1 绪 论 1 1.1 题目背景意义 1 1.2 模具工业在国民经济中的地位 1 1.3 我国塑料模具行业普遍存在的问题 2 1.4 国内外相关研究情况 2 1.5 塑料模发展趋势 3 1.6 设计（论文）主要内容 4 2 塑件的工艺分析 5 2.1 制品(手提箱提手)的简介 5 2.2 分析塑件使用材料的种类及工艺特