注水管线带压施工.docVIP

注水管线带压施工 根据TSG D0001-2009《压力管道安装许可规则》以及《在用工业管道定期检验规程》， 工业管道按压力分：1、低压管道工程压力＜1.6MPa；2、中压管道工程压力1.6-6.4MPa；3、高压管道工程压力6.4-10MPa；4、超高压管道工程压力10-20MPa。 （TSG特种设备技术规范）TSG R1001-2008《压力管道压力管道设计许可规则》， GCl级符合下列条件之一的工业管道为GC1级： (1)输送GB 5044—85《职业接触毒物危害程度分级》中规定的毒性程度为极度危害介质、高度危害气体介质和工作温度高于标准沸点的高度危害液体介质的管道； (2)输送GB 50160－1999《石油化工企业设计防火规范》及GB 50016－2006《建筑设计防火规范》中规定的火灾危险性为甲、乙类可燃气体或甲类可燃液体(包括液化烃)，并且设计压力大于或者等于4.0MPa的管道； (3)输送流体介质并且设计压力大于或者等于10.0MPa，或者设计压力大于或者等于4.0MPa。 焊接人员：压力管道焊工应具备按《特种设备焊接操作人员考核细则》考试合格的焊工合格证，且其合格项目与施焊项目相适应，并在规定的有效期内。 对于高压管道焊接，选用合适的坡口形式是尤为重要的。对于高压水管道都是厚壁管道，考虑到易保证焊接接头的质量、填充金属少、便于操作及减少焊接变形等原则，根据国家规范（《工业金属管道工程施工及验收规范》（GB50235-2010）以及我们在以往高压水工程的施工经验，壁厚的管道采取V型或U型坡口形式。壁厚在9 mm-26 mm之间的管道采取V型坡口形式，管道坡口形式见下表 is also called, to the Organization and his comrades farewell, King of Japanese as a repeat, he moved to Shanghai, Japan Court, killed in Nanjing puppet after prison. Wang Huapeng fullness alias King in prison, sacrificed at the age of 25. Was in August is also called, to the Organization and his comrades farewell, King of Japanese as a repeat, he moved to Shanghai, Japan Court, killed in Nanjing puppet after prison. Wang Huapeng fullness alias King in prison, sacrificed at the age of 25. Was in August is also called, to the Organization and his comrades farewell, King of Japanese as a repeat, he moved to Shanghai, Japan Court, killed in Nanjing puppet after prison. Wang Huapeng fullness alias King in prison, sacrificed at the age of 25. Was in August