《某桥两阶段施工图设计(桥梁设计)-说明书》.docVIP

摘 要 本桥中心桩号K190+165.38，全长126.47米，设计荷载公路Ⅱ级，人群荷载3.0KN/㎡，桥面净宽：净—7+2×1.0，上部采用预应力混凝土简支T梁，横截面由4片梁构成，纵向跨径40.5米，3跨。桥面横坡1.5%，桥面纵坡0.5%，桥面铺装采用水泥混凝土。下部采用轻型墩台，钻孔灌注桩基础。 整个设计过程包括四部分内容：水文计算，上部结构设计，下部结构设计，施工工艺设计。确定了桥梁全长与分孔等问题，拟定了上部尺寸，完成了内力计算，上部配筋，截面验算等计算工作，同时也进行了桥梁墩台基础的计算与验算。重点为上部结构的内力计算与配筋计算，截面验算。 计算表明，各项验算符合要求，设计方案合理。 关键词：预应力；混凝土；水泥；简支梁；钻孔桩。 Abstract The center station number of this bridge is K190+165.38, span 126.47 meters, design load roadⅡThe level, the crowd load 3.0KN/㎡, the bridge floor extends only: - 7+2×1.0, upside uses prestressed concrete simple support T Liang only, the lateral section constitutes by 4 piece of Liang, the longitudinal span 40.5 meters, 3 step. The bridge floor transversal grade 1.5%, the bridge floor lengthwise grade 0.5%, the flooring uses the cement concrete. Lower part uses the light platform, the drill hole irrigation pile foundation. Entire design process including four partial contents: Hydrology computation, superstructure design, substructure design, construction technological design. Had determined the bridge span with questions and so on minute hole, has drawn up upside the size, has completed the endogenic force computation, upside the reinforcing bars, computation work and so on section checking calculation, also have simultaneously carried on the bridge platform foundation computation and the checking calculation. Key for superstructure endogenic force computation and reinforcing bars computation, section checking calculation The computation indicated that each checking calculation meets the requirement, the design proposal is reasonable. The keywords: Pre-stressed; Concretes; Cement; Simple beam; Drills a hole the pile. 目 录 摘 要………………………………………………………………………………Ⅰ Abstract…………………………………………………………………………Ⅱ 绪论……………………………………………………………………………1 1.1概述……………………………………………………………………………1 1.2 国内外研究现状…………………………………………………………………1 1.2.1国内研究现状……………………………………………………………………1 1.2.2国外研究现状……………………………………………………………………1 1.3 工程概况………………………………………………………………………2