《鹤壁大禹煤矿矿井设计—采矿工程毕业设计说明书》.doc

河北联合大学轻工学院 QINGGONG COLLEGE, HEBEI UNITED UNIVERSITY 毕业设计说明书 设计（论文）题目：鹤壁大禹煤矿矿井设计 学生姓名： 学 号： 专业班级： 学 部：工程教育部 指导教师： 2013年5月20日 摘 要为矿t/a新井设计。煤矿位于省禹州市西北交通便利井田走向（）长约，倾向（）长约，井田总面积为2。主采煤层为号煤，平均倾角为，煤层平均总厚为m。井田地质条件较为简单ABSTRACT This s a new design of DaYu mine with a production of 1.2Mt/a. DaYu mine lines in Northwest of Yuzhou in HeNan province. . The traffic of road and railway is very convenience to the mine. The run of the minefield is 3.9-4.2km ,the width is about 2.2km，well farmland total area is ㎞2.The is the main coal seam, and its dip angle is 13 degree. The thickness of the mine is about 10m in all. The proved reserves of the minefield are 121.6Mts. The recoverable reserves are 85.5Mts.The service life of the mine is 67.8 years. The normal flow of the mine is 263m3 percent hour and the max flow of the mine is 447 m3 percent hour. The mineral well gas gushes the deal lower, for low gas mineral well. The well farmland is two level in shaft well to expand. The level should be located at the lever of ±0m and -250m, which use raise and dip mining method of vertical shaft development. The main shaft skip install skip and the auxiliary shaft install cage. The two wings opposite angles ventilation system is used in the mine. The working system “four-six” is used in the Dayu mine. It produced 330d/a. This design includes ten chapters: 1.An outline of the mine field geology; 2.Boundary and the reserves of mine; 3.The service life and working system of mine; 4.development engineering of coalfield; 5.The layout of banes; 6.The method used in coal mining; 7.Transportation of the underground; 8.The lifting of the mine; 9.The ventilation and the safety operation of the mine; 10.The basic economic and technical norms. Keywords：vertical shaft development ;two wings opposite angles ventilation system ;Fully mechanized caving ;ventilation of coal pits. 目 录 第一章 矿区概述井田地质特征 1 1.1 矿区概述 1 1.1.1 交通位置 1 1.1.2 地形地貌 2 1.1.3 河流及水体 2 1.1.4 气象及地震 2